AKG K240-familien:
Nedenstående er en sammenstilling af oplysniger fra HeadFi. Det bliver for rodet at indsætte kilder overalt, så jeg håber de betrufne HeadFi-medlemmer kan leve med ikke at blive krediteret direkte. Jeg overvejede at fordanske sammenstilingen, men i første omgang får det lov at stå på engelsk. Der bliver muligvis også tilføjet mere henad vejen. Specifikationer for de forskellige modeller findes i trådens første indlæg.
---
AKG K240 Sextett
- AKG K240 Sextett.jpg (73.44 KiB) Vist 24658 gange
The Sextett is the original version of the K240, first made in 1975. The name "Sextett" refers to the ring of six passive radiators. These are like little driver membranes without voice coil behind them. They give a very precise control over how the acoustic backwave returns to the listener's ear, crucial for spatial presentation and general frequency response.
This construction was used in a few other AKG models of the time as well, most notably the K340. Here only five radiators were used, however, as the sixth spot was occupied by what some refer to as the crossover.
The Sextett can be identified by the color of the metal rings on the earpieces (silver, not gold), by the large round perforations in the headband (also used to identify "Cardan" versions in general), and by the appearance of the inner side of the earpiece, where the passive radiators are visible behind a plastic grill, encircling the driver.
Construction-wise the K240 sextett appears in 4 different versions, based on 2 different drivers and 3 different radiators:
1. Early Production: Driver A, Radiator A
2. Early-Middle Production: Driver A, Radiator B
3. Late-Middle Production: Driver A, Radiator C
4. Late Production: Driver B, Radiator C
However, the 2 drivers are functionally and sonically identical, so sonic differences can be attributed to the baffle plate/passive radiator, leaving only 3 different versions sonically:
1. Early Production - Orange radiators with orange backing
2. Middle Production - White radiators with orange backing
3. Late Production - White radiators with grey or black backing, plus four pinholes in the baffle
Soundwise bass is said to be reduced when moving from EP to MP to LP, and lower midrange is reduced and treeble increased when moving from MP to LP. The four small holes in the LP baffle/radiator let some sound pass through, bypassing the radiators, which would likely account for the sound being slightly tilted away from the bass and towards the treble, and it is possible that the driver change was done to counter-balance some of the effects of the pinholes. So, within the context of K240 Sextett the EP version will be the 'warmer/bassier' one, and the LP version the 'cooler/airier' one, with the MP version somewhere in between.
Because of how much the parts are mixed, it can be difficult to tell the middle and late production versions apart. Some are obvious by using all early or all later parts, but most are mixed up. The earliest one is easy to tell, because it always has the headband with holes (and a better quality one too), the non-flat grille, orange radiators, more glossy plastic, "AKG" is written in silver inside a black box on the badge, and has a different kind of cord. Some of the middle production have these features, but not necessarily all of them together.
Eventually AKG released the K241, a more cost-effective model which used the same baffle as the late production Sextett, but with no passive diaphragm (and the two different densities of filter material front and back), but with what was called variable acoustic resistors (a principle patented by AKG). K240 Monitor then replaced K240, K241 was discontinued, and (in some markets) the Sextett was marketed for a while as K242. After a while the K240 Monitor went from six big patches to a larger number of smaller patches, closer to the driver.
AKG K240 Diffuse-Field
- AKG K240 DF.jpg (115.04 KiB) Vist 24658 gange
The K240 DF was produced from early 1980s to mid 2000s, and as with most AKG models there are several versions:
1. The early ones with dual-entry cable and 1/4 plug (early to mid eighties)
2. The single-entry ones with big sound ports (aka K241 baffle)
3. The ones with smaller sound ports covered by paper-like patches
4. The ones with smaller sound ports covered by cloth-like (woven) patches
To identify the version at hand remove the foam insert/disc covering the driver (this is only attached loosly under the earpads). The earlier version will have 6 large baffle vents/sound ports (3 in white and the other 3 in black or light blue/grey).
The late production version came with a 1/8 plug + 1/4 adapter, instead of 1/4 plug only.
The earlier version is said to be a bit warmer sounding and with more emphasis on the mids, where the later production is more linear, detailed and has a larger soundstage.Â
The diffuse-field equalization is intended to produce a flat frequency response, thus providing an uncolored sound, which is also how K240 DF seems to be perceived by most listeners. To some this sound signature wil be the right kind of neutral, to others it will be too lean/boring.
There are a number of mods to slightly alter the balance..
A. Pads: The stock pleather pads can be exchanged for velour ones to reduce bass. A thin inlay under the pads will increase bass (careful not to block the baffle vents).
B: Outer foam disc: Sits inside cup between driver and ear. Can be pulled out (and put in again) easily. Without it sound gains clarity.
C. Inner foam ring: Usually disintegrated due to ageing, removing the clutter/gunk might reduce bass/increase clarity. The original foam ring is still available, replacing the disintegrated one will be beneficial also. Basically the foam ring on the inside of a K240 is there to keep the frame parts from banging together. It's nice to have and prevents some mechanical noises.
D. Vent filtering: Check that filter material isn't torn. If paper-like material something like coffee filter paper can be used. If fabric-like material something like upholstery lining ("cambric") can be used.
E. Clamping force: Tighter fit means more bass. The construction doesn't as such cater for clamping force adjustment, though replacing the (often tired or missing) elastics will help in maintaining correct clamping.
F. Balanced cable: Running K240 DF balanced is claimed to musically transform them*. Requires re-wiring, make sure to mark positive and negative wires on both ends to prevent phase inversion.
* )"The phones are incredibly musical with extremely good transient response and micro-dynamics persevered with the macro-dynamics as well now. The bass presentation now is very articulate with the character of each instrument preserved and weighted great within the context of the musical piece. The whole midrange has more presence without the glare or artificial sibilance. The whole presentation opened up."AKG K240 Monitor
- AKG K240 Monitor.jpg (65.24 KiB) Vist 24658 gange
The K240 Monitor was introduced at the same time as the K240 DF, and was manufactured alongside the whole period (early 1980s to mid 2000s). According to AKG tech support the two are identical in the mids and highs.
The early monitors use the sextett baffles (so did the early DF's), then later models used woven fabric with more ports, and then later on a weird type of woven paper, and then just cheap paper ports (closer to what the studio uses on the newest ones), before akg fully discontinued them.
The K240 Monitors are hard-wired, and have 'gold' rings. The earlier monitors are balanced with a 4-core wiring and a silver 1/4'' jack (like the sextetts were), and later models are hard-wired with 3-core wiring (shared ground) and a gold 1/8" jack.
They are said to be fairly consistent sounding across versions, with perhaps the 50th Anniversary Editon to stand out slightly in a positve way (if nothing else then for the looks).
AKG K240 Anniversary Edition
- AKG K240 Anniversary Edition.jpg (208.57 KiB) Vist 24658 gange
Manufactured in 1997 (only) for AKG's 50th anniversary. Sometimes refered to as K240 Jubilee, but mostly called K240 Anniversary Edition. This is basically the K240 Monitor with a bit of bling ("Anniversary Edition" insignia on left side, "50 AKG 1947-1957" markings on inside of earpads, Gold AKG lettering on top of leatherette).
AKG K240 Studio
- AKG K240 Studio.jpg (97.78 KiB) Vist 24658 gange
?
AKG K240 Mk II
- AKG K240 MkII.jpg (111.82 KiB) Vist 24658 gange
?
AKG K240 Red Edition
- AKG K240 Red Edition.jpg (124.15 KiB) Vist 24658 gange
?
---
UpshotHistorical upshot from the AKG-forum (unknown if AKG representative or regular forum member):
"The first K240 was introduced in 1975. From its design it looked similar to the K240 models we know from current production. Only the metal rings over the ear cups were of silver colored polished aluminum and the inner headband was perforated. Like in the recent version K240 Monitor a 32mm driver was used but it was surrounded by 6 passive radiators. Each radiator consisted of a membrane attached to a perforated disc covered with carefully selected acoustical friction material. Conventional circum-aural headphones often have a resonance peak in the upper bass region followed by a more or less significant bass roll off. The result: an unnaturally sounding boomy bass. The resonant frequency of the passive radiators in connection with the relatively high friction of the damping material behind these membranes effectively influences this irregularity in the frequency range.
In the region of the bass boost the membranes become transparent to sound waves and thus reduce the air pressure in the coupling cavity between capsule and ears. In that way the bass boost is leveled out. Below this boost-frequency the membranes block the sound waves and the roll-off is compensated. This acoustic principle was invented by Dr. Goerike, co-founder of AKG.
The first K240's had a four core cable and were available in two connector versions. One had the standard 6,3 mm stereo jack while the other carried a 5 pin connector according to the German DIN standard. This plug was known as Wuerfelstecker (Wuerfel = dice) because the 5 pins were arranged like the dots of a dice. The advantage was that the connector could be plugged into an amp or TV set in two directions. One caused the internal speaker to be turned off, while in a 180-degrees turned position both speaker and headphones were on. For this trick it was necessary to have all four terminals of the headphone drivers connected to the plug.
In France the K240 was named K242 for marketing reasons and during the first years of it's production.
Headphones with the same working principle as the K240 but with individual design were built by AKG for Philips (N6330), Saba (H200) and Uher (W774 and W775).
Although the first series of the K240 were a great success, there were certain discussions among the experts at AKG if the same effect as achieved by the passive radiators could be reached or even surpassed by a different design possibly less critical in production. This brought the introduction of the K241 where instead of the passive radiators only various sound ports covered by acoustically resistive material were used. The dynamic drivers were surrounded by apertures closed by carefully selected friction materials with various values of perviousness related to the acoustic impedances of the outer ear. The K241 was introduced in 1979.
Soon after the introduction of the K241 it's principle of the variable acoustic resistors – patented by AKG – was applied to the K240 as well and replaced the passive membranes.
In 1984 AKG introduced the K240DF, acoustically equalized to the diffuse sound field. The K240DF refers to such a sound field present in a reverberation chamber using third-octave filtered pink noise and measured in the close vicinity of the ear drum with a measuring probe. The work of the IRT - Institut für Rundfunktechnik (Institute for Broadcast Technology) in Munich proposed a standard for headphone-monitoring calling for the diffuse field equalization of monitoring headphones coming closest to loudspeaker monitoring, because there existed no current IEC or CCIR standard for such a system. Especially at times, when program material is exchanged between stations internationally and the monitoring facilities may vary it looks extremely sensible to exclude the varying acoustical parameters of the different monitoring rooms and refer to standardized headphone monitoring when comparing program material.
The K240 Monitor as made from 1984 to 2006 was based on the K240 without passive membranes but with the ear related resistive sound ports. It's earshells were decorated with gold colored metal parts and a three core cable with universal 6,3/3,5 mm (1/4" and 1/8") plug was attached.
In 1997 when AKG celebrated it's 50th anniversary the "K240 Jubilee" in limited edition was made. Acoustically a K240M, it had different nameplates and came with a booklet with a short history of AKG.
In 2002 the 'Studio' Series of headphones was launched. A newly developed capsule with low impedance makes these products especially suitable for portable equipment. The cable is easily detachable. The first series had a minijack connection while from 2003 on a miniXLR-connection between earshell and cable is used. In the same year the closed version of the K240 Studio called K 271 was released. "
---
Service / RepairService manual for K240 Sextett/DF/Monitor/Studio and K241:
Spare parts for K240 Sextett/DF